How Much Does a New HVAC System Cost in the Athens Area? What Drives the Price

If you’ve searched for the cost of a new heating and air system, you’ve probably found price ranges so wide they’re no help at all. That’s because the price of a new system depends almost entirely on your house: its size, its ductwork, the system you choose, and how hard it is to install.

 

At Blount Heating and Cooling, we’ve installed and replaced HVAC systems across Athens and Northeast Georgia since 1986. Here’s what actually drives the price, how to compare estimates, and how to keep the cost manageable.

 

What Drives the Cost of a New HVAC System

  1. The type of system. Replacing a central AC and gas furnace, installing a heat pump, adding a dual-fuel system, or installing ductless mini-splits are all distinct projects with varying equipment costs.

 

  1. The size of the system. Systems are sized by tonnage. Bigger homes need more capacity, but bigger isn’t automatically better. An oversized system costs more up front, cycles on and off too often, and does a poor job removing humidity, which matters a lot in Georgia. The right size comes from a load calculation, not a rule of thumb.

 

  1. Efficiency. Higher SEER2 (cooling) and HSPF2 (heating) ratings cost more to buy and less to run. In the Southeast, new split-system central air conditioners must meet a federal minimum SEER2 rating of 14.3. Going above the minimum pays off faster in homes that run the AC hard all summer.

 

  1. Ductwork. If your ducts are in good shape, a replacement can connect to them. Leaky, undersized, or damaged ducts need repair or replacement, and new ductwork is one of the biggest variables in any estimate.

 

  1. Installation conditions. Attic and crawlspace access, the length of refrigerant lines, electrical upgrades, condensate drainage, permits, and the removal of the old equipment all affect labor costs.

 

  1. Add-ons. A new thermostat, whole-home dehumidifier, air purification, or upgraded filtration add to the total but can make a big difference in comfort.

 

What Raises or Lowers the Price

Factor Keeps cost lower Pushes cost higher
System type Like-for-like replacement Switching system types or adding zones
Ductwork Existing ducts in good shape New or redesigned ductwork
Efficiency Federal minimum efficiency High-efficiency, variable-speed equipment
Access Open attic or crawlspace Tight attics, finished spaces, long line runs
Electrical Existing circuit works Panel or circuit upgrades needed
Extras Standard thermostat and filter Dehumidifiers, air purification, smart controls

Repair or Replace? Doing the Math

A new system isn’t always the answer. We always look at repair first, and replacement usually makes sense when:

  • The AC or heat pump is 12 to 15 years old, or the furnace is 15 to 20 years old.
  • A repair would cost close to half the price of a new system.
  • It’s needed several repairs in the last two seasons.
  • It uses R-22 refrigerant, which is no longer produced in the U.S., so recharging an older system is becoming increasingly expensive.

 

If your system is near the end of its life, replacing it on your schedule usually costs less than replacing it in an emergency in July. Learn more about AC replacement and heating installation.

 

What a Good HVAC Estimate Should Include

When you compare quotes, make sure each one spells out:

  • The exact equipment, with brand, model numbers, and efficiency ratings
  • How the system was sized
  • What happens with your ductwork
  • Electrical work, permits, and removal and disposal of the old equipment
  • The thermostat and any add-ons
  • The manufacturer’s parts warranty and the contractor’s labor warranty

 

If one estimate is much lower than the others, it’s usually missing something on this list.

 

Ways to Manage the Cost

Financing. Blount offers financing through the Carrier credit card, issued by Wells Fargo Bank, N.A., subject to credit approval. Monthly payments can make a better system fit your budget. See our financing page for details.

 

Plan ahead. Spring and fall are the best times to replace a struggling system. You’ll have more time to compare options than you will when the AC dies on the hottest week of the year.

 

Check for rebates. The federal Energy Efficient Home Improvement Credit (25C) isn’t available for equipment placed in service after December 31, 2025. Some electric utilities offer their own programs, so it’s worth asking your provider before you buy.

 

Protect the investment. Members of our Preventative Maintenance Agreement get 5% off new equipment and indoor air quality systems, plus two tune-ups per year to keep the new system running efficiently.

 

HVAC Cost FAQs

How long does it take to replace an HVAC system?

A straightforward like-for-like replacement is often done in a day. Projects with new ductwork, a different system type, or electrical upgrades take longer.

 

Is it cheaper to replace the AC and furnace at the same time?

Often, yes. You’ll pay for one installation instead of two, and you’ll get matched equipment designed to work together. If one part of your system is newer and in good shape, we’ll tell you.

 

Will a bigger system cool my house better?

Not usually. An oversized system short-cycles, wears out faster, and leaves the house humid. The right size is the one that matches your home’s actual heating and cooling load.

 

How do I get an estimate?

We visit your home, assess your needs,s and give you a clear, upfront estimate before any installation begins.

 

Get a Clear Estimate on a New System

Blount Heating and Cooling installs air conditioners, heat pumps, furnaces, and mini-splits in Athens, Bogart, Watkinsville, Winder, Jefferson, and across Northeast Georgia. We’re family-owned, licensed in Georgia (License #CR005833), and we’ll always tell you if a repair makes more sense than a new system. Request an estimate or call (706) 548-6933.

Read more